Currie JK-RJIIIR Bolt-In JK RockJock 60 Rearend Unit (35 Spline)

$2,175.99
In stock
SKU
JK-RJIIIR
Currie Enterprises JK-RJIIIR Bolt-In JK RockJock 60 Rearend Unit (35 Spline)
The RockJock III high pinion rearend assembly for the 2007 and up Jeep JK includes the complete housing with the 65-45-12 ductile iron housing center, AR400 heat treated bottom skid plate allowing the axle to slide over rocks easily, 3" x .250" wall d.o.m. steel tubes, heavy duty steel diff cover, yoke (1310/1330/1350 optional), and custom housing ends that accept set 80 axle bearings (over 50% greater capacity than stock) and allow for all factory disc brake hardware and ABS and ESP sensors to bolt back on. All new heavy duty Currie Jeep JK suspension brackets are mounted and feature multiple control arm mounting holes, multiple trac bar mounting holes, and adjustable shock mounting holes. Also included are the Currie performance forged alloy 35 spline axle shafts (specify wheel bolt pattern needed when ordering, dual bolt patterns are optional). Axles feature wheel studs, ABS tone rings, and axle bearings pressed on, as well as the bearing retainer plates. All you need to complete this unit is a high pinion Dana 60 ring and pinion gear set, Dana 60 35 spline carrier of your choice, a center section bearing & set up kit and labor to set it up! Your JK's stock rotors, calipers, and caliper mounting brackets transfer over! This unit is 66" wide
More Information
Year 2007 - Present
Make Jeep
Model JK
Engine All
Write Your Own Review
You're reviewing:Currie JK-RJIIIR Bolt-In JK RockJock 60 Rearend Unit (35 Spline)
Copyright © 2017 Casey Currie Motorsports. All rights reserved.